Abaqus Volume II: I–Z Manual do Utilizador descarregar pdf (Página 197)

100

101

NMAP

3. Y-coordinate of the point to which this control node is to be mapped.

4. Z-coordinate of the point to which this control node is to be mapp ed.

Second line:

1. Node number of the second control node.

2. X-coordinate of the point to which this control node is to be mapped.

3. Y-coordinate of the point to which this control node is to be mapped.

4. Z-coordinate of the point to which this control node is to be mapp ed.

Continue, giving up to 20 control nodes, but giving at least the eight corner nodes. If an edge of the

blended mapping is to be mapped linearly, the corresponding mid-edge control node can be omitted from

the list. This is done by inser ting a line with node number 0 only (a blank line) in place of the deﬁnition

of the control node and its mapped coordinates. The control nodes do not have to be nodes in the ﬁnite

element model—they can be nodes used just for mesh generation. ABAQUS eliminates any nodes that

are not used in the analysis model before doing the analysis.

14.4–3

ABAQUS Version 6.1 Module:

ID:

Printed on:

1 2 ... 192 193 194 195 196 197 198 199 200 201 202 ... 627 628

Comentários a estes Manuais

Sem comentários

Abaqus Volume II: I–Z Manual do Utilizador Página 197

Comentários a estes Manuais